Setting RMxprt Options

To specify settings for RMxprt options:

  1. Click Tools > Options > General Options to open the Options window, displaying a hierarchical list of options.
  2. Click the + button next to RMxprt to show the following choices: General, Machine Type, Threshold.
  3. In the General options panel, select or clear the following check boxes:
    • Save before solving – Note that when you enable this setting, the project is only saved if it has been modified since its last save.
    • Apply variation deletions immediately

  4. On the Machine Type panel, to change the default machine type when you initially insert a design, select one of the following from the Default machine type drop-down menu:

    • Three-Phase Induction Motor
    • Single-Phase Induction Motor
    • Three-Phase Synchronous Machine
    • Brushless Permanent-Magnet DC Motor
    • Adjust-Speed Synchronous Machine
    • Permanent-Magnet DC Motor
    • Switched Reluctance Motor
    • Line-Start PM Synchronous Motor
    • Universal Motor
    • DC Machine
    • Claw-Pole Synchronous Machine
    • Three-Phase Non-Salient Synchronous Machine
    • Generic Rotating Machines

  5. On the Threshold panel, enter the Default conductivity and Default permeability values in siemens/m.

    6. Note: Setting the material thresholds under Tools > Options impacts the default setting for the current and all future projects/designs. To change the material threshold for the current design only, use the RMxprt > Design Settings window to change the material thresholds on the Set Material Thresholds tab.
  6. Click OK to close the window.