Schematic Editor Options: Wiring Tab

The following options are set on the Wiring panel under Schematic Editor in the Options window.

Connectivity Options:

• Show Merge Wire dialog before combining wires – displays the Merge Wire dialog box before combining wires to allow for changes to the merge configuration.
• Show Split Wire dialog before separating wires – displays the Split Wire dialog box before separating wires to allow for changes to the split configuration
• When renaming a physically separate piece of wire, there are two choices:

– Split into a different net

– Keep connected (name all pieces the same)

• Show GlobalPort Disconnect dialog before separating – displays the GlobalPort Disconnect dialog box before separating wires to allow for changes to the global port configuration.