PMCore UDP
The PMCore UDP is used to create a PM stator/rotor core and a PM for PM commutating DC machines, PM adjustable-speed synchronous machines, or PM brushless DC motors.
|
Property |
Description |
|
DiaGap |
Core diameter on gap side, DiaGap<DiaYoke for outer cores. |
|
DiaYoke |
Core diameter on yoke side, DiaYoke<DiaGap for inner cores. |
|
Length |
Core length. |
|
Poles |
Number of poles. |
|
PoleType |
Pole type: 1 to 5. |
|
Embrace |
Pole embrace (not for type 4). |
|
ThickMag |
Max thickness of magnets. |
|
WidthMag |
Magnet width (for types 4 & 5). |
|
Offset |
Pole arc offset (for types 1, 2 & 3). |
|
Bridge |
Bridge thickness (for type 5 only). |
|
Rib |
Rib width (for type 5 only), Rib=0 for rectangle ducts. |
|
LenRegion |
Region length. |
|
InfoCore |
0: core; 1: magnets; 2: magnet; 100: region. |
These parameters are used in the figures that follow.
PM Core with PoleType set to 3 (InfoCore set to 0) shows the Offset parameter when value of PoleType is 3.
PM Core with PoleType set to 5 (InfoCore set to 0)
PM Core with PoleType set to 3 (InfoCore set to 0)